Bont Sizing- Inline Skate Boots

Skate boots are not like your average shoe. For maximum control, your boots need to fit like a second skin. That is why Bont boot sizing is NOT the same as your UK shoe size or other skate brand sizing. Wear the type of socks you’ll wear with your boots and distribute your weight evenly before measuring.

How to Measure Your Feet

Step 1

On a hard surface, tape a piece of blank paper to the floor. Stand up straight with your foot on the paper. Your heel should be barely touching the wall — or not at all. Do not push your heel into the wall as it will produce incorrect length measurements.

Step 2

Mark the longest part of your foot (heel-to-toe length) and the widest part on the paper with a pen or pencil. If your heel is away from the wall, trace around your whole foot. Make sure your pen is held vertically, not at an angle. Repeat with the other foot, as left and right may differ.

Step 3

Use a ruler to measure the heel-to-toe length and width for each foot. Compare these measurements to the size chart below.

---

Note: This size chart does not apply to the Eclipse, Slipstream, or new Vaypor boots. For these models, measure your feet in mm and select your size on the product page.

This chart is a guide and may not work for all feet. It applies to models such as the Jet and Semi Race III. If you have a narrow or wide foot, please send us a drawing of your feet with length and width shown.

Size Chart